Set up your gadget with your phone
Your gadget came with a printed label. Its builder has already prepared it for the operator’s gateway. With the label and a phone you can join the gadget to your home Wi-Fi. Wi-Fi setup needs no computer, separate setup app or setup account. After joining, the gadget shows Online or a code for Grok Bot.
On this page
Status: Phase 10 (ADR 010). On 14 October 2026 the owner set up one kit this way with an iPhone and with an Android phone (record). This record covers Wi-Fi setup, not Android Grok Bot calls.
What you need
- The gadget and its label. Keep the label private: it works like a key.
- An iPhone or an Android phone with its normal camera.
- Your home Wi-Fi name and password. The gadget uses 2.4 GHz Wi-Fi only.
- A USB charger for the gadget.
Set it up
- Plug the gadget into the charger. The screen shows
Setup 10 minand a name such asGrokGadget-89AB. You have 10 minutes. - Open the phone's camera and point it at the QR code on the label. Tap Join when the phone offers the gadget's Wi-Fi.
- The phone opens the Set up your gadget page. If it does not, open the browser and go to
192.168.4.1. - Type the setup code from the label and tap Continue.
- Pick your home Wi-Fi from the list, type its password and tap Join.
- Wait about 20 seconds. The page confirms the connection. The gadget shows Online or
Code XXXX-XXXX. Wi-Fi setup is complete; claim it next if it shows a code.
Next: claim it in Grok Bot
When the screen shows a code, follow Claim your gadget. You will connect Grok Bot to the relay and claim the gadget for your relay account. Then ask Grok Bot: "Show hello on my gadget."
If something goes wrong
| The screen or page shows | Do this |
|---|---|
Wrong password |
Type the password again and tap Join. Check upper and lower case. |
No network |
Use a 2.4 GHz network. Check the network name. |
Join timeout |
Check that the router is on and near the gadget. Try again. |
| "That setup code is not right" | Check the code on the label. 0 and O, 1 and I are never used. |
| "Too many wrong codes" | Wait for the time on the page, then try again. |
Setup closed and Power cycle |
Unplug the gadget, plug it in again, and start from step 2. |
Setup locked |
Too many wrong codes. Unplug the gadget and plug it in again. |
| The page drops while joining | Normal for a few seconds. Watch the gadget's screen for the result. |
Move to a new network
Hold the gadget's BOOT button for 10 seconds. The screen counts down and the gadget forgets your Wi-Fi. It keeps its relay account owner. It opens its setup Wi-Fi again: start from step 1.
To give it away, follow Hand a gadget to someone. A BOOT reset alone does not transfer ownership.
Privacy
- The gadget sends your Wi-Fi password to nobody. It stores the password on the gadget only.
- The setup page never shows a stored value.
- Anyone who holds the gadget can read what it stores. If you give the gadget away, reset it with BOOT first.